Unusual Dry Deposition

Topics about the HYSPLIT dispersion model.
Post Reply
Smaug
Posts: 53
Joined: July 1st, 2017, 8:28 am
Registered HYSPLIT User: No

Unusual Dry Deposition

Post by Smaug » July 30th, 2019, 2:27 pm

Hello,

I am aware that HYSPLIT should generally not be used for a single site profile but I am doing a comparison and I need to run with a single site profile. My peak deposition values I am getting are very small compared to another model I ran and they are smaller by 3 orders of magnitude. I have given them the same met and source term but HYSPLIT is consistently producing smaller deposition values through out the simulation.

I am getting an issue where I am making the particles heavier but the maximum deposition seems to be maxed out and not increasing further. I have attached my CONTROL and SETUP file so you can check that I am understanding this correctly.

Is there some sort of limit that is causing this or will it depend on the rate of particle release?

Thanks,
Attachments
SETUP.CFG.txt
(72 Bytes) Downloaded 8 times
CONTROL.txt
(274 Bytes) Downloaded 12 times
EMITIMES.txt
(76 Bytes) Downloaded 10 times

Post Reply