HYSPLIT Forum: hysplitbbs.arl.noaa.gov

Hello,

My intention is to set up a case using the captioned approach in order to know what fraction of air concentration at Mauna Loa (i.e. the receptor) was contributed by a grid of sources located in South/southeast Asia (the control file attached). After I run the model, I set the lat. and long of Mauna Loa at concentration/display/source-receptor/view/extraction method/receptor/lat. = 19 and long. = -155, an error message appears ("Receptor selection outside of concentration grid", see below). When I change the long. to 180 degree, results are given but wrong (>> 100%, attached). I tried to change the center of Lat and Lon in concentration/setup run/definition of concentration grid with long. = -155 or -170 or 120 but still appears the error message below.

Would you suggest how to fix it?

Thanks.

Best wishes,

Peter




_____________________________________________
Receptor selection outside of concentration grid
Nearest grid point to selection: 30.00000 52.00000
Enter to continue ...
forrtl: 管道已結束。

forrtl: severe (24): end-of-file during read, unit -4, file CONIN$
Image PC Routine Line Source
matrix.exe 000000013FF4A662 Unknown Unknown Unknown
matrix.exe 000000013FF36EC9 Unknown Unknown Unknown
matrix.exe 000000013FF13423 Unknown Unknown Unknown
matrix.exe 000000013FFA2E6E Unknown Unknown Unknown
matrix.exe 000000013FF8C91B Unknown Unknown Unknown
kernel32.dll 00000000773C59ED Unknown Unknown Unknown
ntdll.dll 00000000775FC541 Unknown Unknown Unknown
Receptor selection outside of concentration grid
Nearest grid point to selection: 30.00000 52.00000
Enter to continue ...
forrtl: 管道已結束。

forrtl: severe (24): end-of-file during read, unit -4, file CONIN$
Image PC Routine Line Source
matrix.exe 000000013FF4A662 Unknown Unknown Unknown
matrix.exe 000000013FF36EC9 Unknown Unknown Unknown
matrix.exe 000000013FF13423 Unknown Unknown Unknown
matrix.exe 000000013FFA2E6E Unknown Unknown Unknown
matrix.exe 000000013FF8C91B Unknown Unknown Unknown
kernel32.dll 00000000773C59ED Unknown Unknown Unknown
ntdll.dll 00000000775FC541 Unknown Unknown Unknown
while executing
"exec $exec_dir/matrix.exe $arg1 $arg2 $arg3 $arg4 $arg7 $arg5 $arg6"
(procedure "run_srm_plot" line 25)
invoked from within
"run_srm_plot"
invoked from within
".srmdisp.bot.save invoke"
("uplevel" body line 1)
invoked from within
"uplevel #0 [list $w invoke]"
(procedure "tk::ButtonUp" line 24)
invoked from within
"tk::ButtonUp .srmdisp.bot.save"
(command bound to event)

Can you please send me the MESSAGE file that you get after you run the model?

Hello,

I have overwritten the message file by another model run. When I delete all the files from my previous runs and run the given control file again, the modelling results are normal (i.e. < 100%) now, although I don't know why. So I think the problems were solved.

Thanks.

Peter