HYSPLIT Forum: hysplitbbs.arl.noaa.gov

After converting the WRF output file for a month from January 1, 21, I set the model setup as


Starting time (YY MM DD HH) : 21 01 01 00
Number of starting locations : 1
Total run time : 24
Direction : Fwrd
Top of model 10000.0


Then run model, and it works, so completed successfully. But when I tried to display the results, an error occurred


Error: Started Tracectory Drawing
HYSPLIT version: hysplit.v5.2.1
Last Changed Date: 2022-05-16
ERROR: no trajectories to plot 900


The following is my output content.


1 1
AWRF 21 1 1 0 0
1 FORWARD OMEGA
21 1 1 0 35.824 127.148 500.0
1 PRESSURE
1 1 21 1 1 1 0 0 0 0.0 35.824 127.148 500.0 957.8


Could you tell me the configuration of this output file?
It was a different configuration output from when the model was successful

Please attach the SETUP.CFG, CONTROL, and MESSAGE files from the failed run for diagnosis. The format of trajectory dump files are described at https://www.ready.noaa.gov/hysplitusersguide/S263.htm.