dry vs. wet deposition quantification

Post questions, comments and links to research (research papers, web sites, etc) involving HYSPLIT and atmospheric dust. This section is also to facilitate collaborations between researchers involved in dust transport and dispersion.
Post Reply
NicoCosentino
Posts: 1
Joined: December 9th, 2019, 12:49 pm
Registered HYSPLIT User: Yes

dry vs. wet deposition quantification

Post by NicoCosentino » December 9th, 2019, 12:59 pm

I run concentration simulations and I do particle deposition. I turn on both dry and wet deposition, and I usually run 24-hour simulations with point-source emissions with a fixed emission rate. Once simulations are over I usually plot deposition rate fields. However, I would like to quantify how much of the total deposition is due to dry and how much to wet deposition. One way would be to switch only one of those two in different runs and compare... but I assume that the deposition field for a simulation with both dry and wet turned on is not just the sum of dry deposition with wet turned off and of wet deposition with dry turned off. Is there a way to quantify these relative contributions?

alicec
Posts: 170
Joined: February 8th, 2016, 12:56 pm
Registered HYSPLIT User: Yes

Re: dry vs. wet deposition quantification

Post by alicec » December 9th, 2019, 3:31 pm

There is no way to separate the deposition due to the different mechanisms in the output.
Running them separately will give you some idea of the different contribution, although as you note, it is not
a simple sum e.g. dry deposition depends on concentration in lowest layer which could be altered by wet deposition.

Post Reply