Query on HYSPLIT MPI version

General questions and postings pertaining to the use of HYSPLIT regardless of the platform. For platform specific questions, use the HYSPLIT Platform forums.
Post Reply
vikrant_sapkota
Posts: 1
Joined: August 29th, 2018, 11:56 pm
Registered HYSPLIT User: No

Query on HYSPLIT MPI version

Post by vikrant_sapkota » August 30th, 2018, 12:23 am

Hi,
Currently I am using HYSPLIT linux version for simulating BC concentration in Nepal using Egar HTAP emission inventory. Since the inventory is gridded and consists of more than 70000 grid points, the runtime for 8 day HYSPLIT has been over 96 hours when running in serial mode.

Parallel version using MPICH does not show much improvement in the run completion time. It seems to us that the parallel runs are correct; it shows all cores being run when checking via top command and creates all the MESSAGE files corresponding to the number of processors used. However, the runtime is the same as serial version if not slower. Please find attached a control file, emitimes file, one message file of a sample run with 300 gridded points. The run time for this trial was ~2 hours for both serial and parallel runs. My system details is as follows " Linux opensuse 4.4.140-62-default #1 SMP Tue Jul 17 12:14:34 UTC 2018 (951943d) x86_64 x86_64 x86_64 GNU/Linux". I have use hycm_std executable for the mpi run.

Any help from your side regarding the matter would be greatly appreciated.




Regards,
Vikrant Sapkota
CONTROL.txt
(9.63 KiB) Downloaded 25 times
The attachment EMITIMES.txt is no longer available
The attachment CONTROL.txt is no longer available

Post Reply