#9.2 Step 5
#9.2 Step 5
Can you explain how to define two layers, as suggested in step 5 of section 9.2? There's no accompanying graphic and I can't see where in the Setup Run menu this can be adjusted. Thanks!
-
- Posts: 81
- Joined: August 15th, 2017, 3:59 pm
- Registered HYSPLIT User: No
Re: #9.2 Step 5
When setting up a concentration run, concentration levels are defined as follows: Concentration > Setup Run > Pollutant, Deposition and Grids setup button > Grid 1 (for the first concentration grid):
Set the number of vertical levels
Set the height of levels
If the number of vertical levels is set to 1 and the height of levels set to 100, then you have one level from the surface to 100m.
If the number of vertical levels set to 2 and the height of levels set as 800 1000, then you have one level set from the surface to 800m and another set from 800m-1,000m.
To change the level in a contour plot (i.e., Concentration > Display > Concentration > Contours menu), chose the level information (Vertical Display, From Bottom Level, Through Top Level).
Set the number of vertical levels
Set the height of levels
If the number of vertical levels is set to 1 and the height of levels set to 100, then you have one level from the surface to 100m.
If the number of vertical levels set to 2 and the height of levels set as 800 1000, then you have one level set from the surface to 800m and another set from 800m-1,000m.
To change the level in a contour plot (i.e., Concentration > Display > Concentration > Contours menu), chose the level information (Vertical Display, From Bottom Level, Through Top Level).