Multiple species simulations
-
- Posts: 2
- Joined: September 20th, 2019, 11:09 pm
- Registered HYSPLIT User: Yes
Multiple species simulations
We can't run Cs-137 and I-131 at the same time, right? Thank you
-
- Posts: 81
- Joined: August 15th, 2017, 3:59 pm
- Registered HYSPLIT User: No
Re: Multiple species simulations
Yes, you can run with multiple species. In the Concentration Setup menu 1) click on the Pollutants, Deposition, and Grids setup button; 2) under pollutant change =1 to =2; and 3) click on specie 1 and specie 2 under pollutant and deposition to configure the emissions rate and deposition properties for the two species.
Re: Multiple species simulations
You can run multi radioactive nuclides in two ways.
1) As Chris suggested, set multiple pollutants with each decay rate.
2) Run the simulation for radionuclides and noble gases without decaying rate. Apply decay rate later using a post-processing tool. This is what Roland showed in 15.3, and it can save simulation time for the multi-species run.
Hyun
1) As Chris suggested, set multiple pollutants with each decay rate.
2) Run the simulation for radionuclides and noble gases without decaying rate. Apply decay rate later using a post-processing tool. This is what Roland showed in 15.3, and it can save simulation time for the multi-species run.
Hyun
-
- Posts: 2
- Joined: September 20th, 2019, 11:09 pm
- Registered HYSPLIT User: Yes
Re: Multiple species simulations
Thank you!