Inline WRF-HYSPLIT

Post Reply
emilygordon
Posts: 1
Joined: October 15th, 2021, 12:15 pm
Registered HYSPLIT User: Yes

Inline WRF-HYSPLIT

Post by emilygordon »

I'm trying to set up a WRF/HYSPLIT simulation through READY. My first simulation ran successfully (a month or two ago) but when I tried a new setup with the same parameters except altering the release date to be 1 day earlier, I get an error at the very end of the simulation. Here are the last few lines from the model status file:

===run post-processing===
Finished in-line WRF/HYSPLIT simulation for job 290.
The model is now complete.
Fri Oct 15 11:42:45 EDT 2021

******************************************************************************
The model has crashed. Check the HYSPLIT Message file for further information.
******************************************************************************
cp: cannot stat 'hys-out/print.rsl.inline': No such file or directory
cp: cannot stat 'hys-out/CONTROL': No such file or directory
cat: CONTROL.290.txt: No such file or directory


The full status file is attached. No other files were created during the run. Is this caused by a problem in my setup, or is this a problem with READY?
Attachments
progress_WRF_Inline_290.txt
(24.75 KiB) Downloaded 2596 times
Post Reply

Return to “HYSPLIT on the READY Server”