Multiple fires at the same time?
Multiple fires at the same time?
It's possible, just as in the case of the dust storms, to place several fires points at the same time?
Re: Multiple fires at the same time?
Yes, you can put multiple locations in the CONTROL file.
If you are using the EMITIMES file for emission, it should have corresponding locations as those in CONTROL.
If you are using the EMITIMES file for emission, it should have corresponding locations as those in CONTROL.
Re: Multiple fires at the same time?
Thank you very much.
Re: Multiple fires at the same time?
In the section (16.5) about to create the emissions file, the HEAT column had zero values, in the case of the fire simulations, is the HEAT data essential for calculations or can be also zero?
-
- Posts: 24
- Joined: September 18th, 2017, 2:20 pm
- Registered HYSPLIT User: No
Re: Multiple fires at the same time?
Heat will be important to calculate releae height for smoke emission (see section 14.1).
The example in 16.5 is for volcanic ash applications where the emission heights are explicitly provided in the EMITIMES file. In this case, HEAT is not used.
The example in 16.5 is for volcanic ash applications where the emission heights are explicitly provided in the EMITIMES file. In this case, HEAT is not used.