Accidentally saving the setup file during the run

Post questions about HYSPLIT installation.
Post Reply
vpratap397
Posts: 6
Joined: June 21st, 2020, 10:11 am
Registered HYSPLIT User: No

Accidentally saving the setup file during the run

Post by vpratap397 »

So, while the run is going on, and we are looking through the setup in GUI as we did just a few minutes ago, if we accidentally save it, what will happen to the run which is going on?
christopher.loughner
Posts: 81
Joined: August 15th, 2017, 3:59 pm
Registered HYSPLIT User: No

Re: Accidentally saving the setup file during the run

Post by christopher.loughner »

SETUP.CFG is read at the beginning of the run. Assuming the program already read SETUP.CFG before saving it while it is running, the model simulation should proceed as initially intended.
vpratap397
Posts: 6
Joined: June 21st, 2020, 10:11 am
Registered HYSPLIT User: No

Re: Accidentally saving the setup file during the run

Post by vpratap397 »

Thanks Christopher.
Post Reply

Return to “1. Installing HYSPLIT”