i run dispersion test simulation with hysplit successfully,
but when i tried to run forward trajectory i get an error see below from the rsl.error :
forrtl: severe (174): SIGSEGV, segmentation fault occurred
from rsl.out log ,see below the messages when it stops:
ddd setup trajectories starting points!
tj= 1 56.85840 31.26782 0.9988247
ddd number of trajectories... 1
ddd kpt= 0 1 0.0000000E+00
ddd XPOS= 56.85840 31.26782 0.9988247 0
I attached the CONTROL,namelist.input and rsl.out.
So, please any one can help to solve the problem?
Thanks.
segmentation fault fwrd traj simulation error
-
- Posts: 6
- Joined: March 14th, 2017, 2:41 am
- Registered HYSPLIT User: Yes
segmentation fault fwrd traj simulation error
- Attachments
-
- CONTROL.txt
- (501 Bytes) Downloaded 6592 times
-
- namelist.txt
- (6.91 KiB) Downloaded 6614 times
-
- addfields.txt
- (27 Bytes) Downloaded 6560 times
Re: segmentation fault fwrd traj simulation error
The rsl.out file was not attached.
The error message of "segmentation fault" is not helpful to diagnose what caused the termination of the run. Have you successfully run the simulation without turning on the trajectory?
The namelist file shows that you ran a WRF_CHEM core. The inline version of HYSPLIT is set up and tested with standard WRF_EM. All hysplit routines are in an extra directory (hysp/) included in the WRF model and do not interact (even know) other add-on packages like WRF_CHEM.
The error message of "segmentation fault" is not helpful to diagnose what caused the termination of the run. Have you successfully run the simulation without turning on the trajectory?
The namelist file shows that you ran a WRF_CHEM core. The inline version of HYSPLIT is set up and tested with standard WRF_EM. All hysplit routines are in an extra directory (hysp/) included in the WRF model and do not interact (even know) other add-on packages like WRF_CHEM.
-
- Posts: 6
- Joined: March 14th, 2017, 2:41 am
- Registered HYSPLIT User: Yes
Re: segmentation fault fwrd traj simulation error
Hi,
Yes i can run Hysplit with traj turn off with both standard WRF-ARW or WRF-CHEM,
while always when i turn on traj i got segmentation fault even inline with standard WRF-ARW.
now i atahced rsl.out log file.
Yes i can run Hysplit with traj turn off with both standard WRF-ARW or WRF-CHEM,
while always when i turn on traj i got segmentation fault even inline with standard WRF-ARW.
now i atahced rsl.out log file.
- Attachments
-
[The extension bz2 has been deactivated and can no longer be displayed.]