Trajectory simulation is seemingly executing normally, but it generates no numerical output

[joaolucas]

Hi everyone.

I have executed trajectory simulations using an ARL meteorology file which was converted from NetCDF4.
The simulation process seemingly run without errors or warnings, but no output is generated at end.
Could it be related to the meteorology file ? I sent the header of this file as attachment.
Maybe some wrong nomenclature or missing variable ?

Thank you in advance.

Best regards.

[sonny.zinn]

Could you attach the CONTROL, SETUP.CFG, and MESSAGE files from your run for further diagnosis?

[joaolucas]

Yes, here they are.
I added the suffix txt in order to allow the upload.
Thank you.

[sonny.zinn]

According to the MESSAGE file, all three trajectories were terminated within a few minutes into the simulation because they reached the top of domain:

Code: Select all

  NOTICE advpnt: trajectory above data domain
  Trajectory sigma pt:   0.981210947    
  Top of model domain:   0.981999993

  NOTICE advpnt: trajectory above data domain
  Trajectory sigma pt:   0.978788793    
  Top of model domain:   0.981999993    
  NOTICE advpnt: trajectory above data domain
  Trajectory sigma pt:   0.980180442    
  Top of model domain:   0.981999993   

The top of domain is set to 400 meters in your CONTROL and it may be too low considering the default value is 10000 meters. Please consult https://www.ready.noaa.gov/hysplitusersguide/S262.htm for more information about the top of domain.