Time varying source
Posted: November 22nd, 2018, 7:30 am
Hi,
is it possible to set up a time-varying source with a time variation resolution < 1 hour, both in terms of emission rate and location (e.g. height)?
I am aware of the options explained in the manual at page 193 ("Time Variation of the Emission Rate") but:
- with the EFILE option, apparently I can act on the emission rate, not on the locations (hence height)
- with the restart option, I can again change the emission rate up to a time resolution of minutes, but this does not apply to the locations, since these are controlled from the Concentration Setup run (Total run time). I can run for 1 hour, then change the location heights and then restart, but apparently it does not work if I specify a fraction of hour in the field "Total run time". Unless I am completely wrong...
Thank you
Fabio
is it possible to set up a time-varying source with a time variation resolution < 1 hour, both in terms of emission rate and location (e.g. height)?
I am aware of the options explained in the manual at page 193 ("Time Variation of the Emission Rate") but:
- with the EFILE option, apparently I can act on the emission rate, not on the locations (hence height)
- with the restart option, I can again change the emission rate up to a time resolution of minutes, but this does not apply to the locations, since these are controlled from the Concentration Setup run (Total run time). I can run for 1 hour, then change the location heights and then restart, but apparently it does not work if I specify a fraction of hour in the field "Total run time". Unless I am completely wrong...
Thank you
Fabio