Help with concentration batch script
Posted: October 12th, 2020, 6:50 pm
Hello
I wanted to do some backward concentration runs and since there are
quite a lot of them, I decided to write a batch script to execute them
automatically. However, I encountered a strange issue: If I run the simulation
from the script, it doesn´t properly run and generates no output file,
but if I run exactly the same simulation from the GUI it works just fine.
I have attached my script(only a test version, but essentially the same as I´m trying to do)
and the MESSAGE files for both the script and the GUI runs.
Thank you very much in advance for your help
Fabian
I wanted to do some backward concentration runs and since there are
quite a lot of them, I decided to write a batch script to execute them
automatically. However, I encountered a strange issue: If I run the simulation
from the script, it doesn´t properly run and generates no output file,
but if I run exactly the same simulation from the GUI it works just fine.
I have attached my script(only a test version, but essentially the same as I´m trying to do)
and the MESSAGE files for both the script and the GUI runs.
Thank you very much in advance for your help
Fabian