Page 1 of 1

Help with HYSPLIT Concentration Setup

Posted: September 30th, 2020, 2:58 pm
by katherinebee13
Hello

I am trying to run a wildfire PM2.5 emission simulation of concentrations. However, the control file and setup file I have made, doesnt work and the HYSPLIT will not run. If anyone could help me or offer advice that would be great!
Thank you in advance.

Re: Help with HYSPLIT Concentration Setup

Posted: October 8th, 2020, 8:20 am
by alicec
Can you attach your CONTROL file as well?
Thanks.

Re: Help with HYSPLIT Concentration Setup

Posted: October 26th, 2020, 12:44 pm
by katherinebee13
Here it is! Thank you in advance!

Re: Help with HYSPLIT Concentration Setup

Posted: November 5th, 2020, 9:24 am
by alicec
You do not have the averaging time specified in your control file.
See below the line which is all zeros in bold.
It should be something like
00 01 00
https://ready.arl.noaa.gov/hysplitusersguide/S313.htm


18 11 08 00
1
39.729 -121.626 10.0
36
0
10000.0
1
/ready_archives/nam12/
20181108_nam12
1
PM25
810618.3
36
00 00 00 12 00
1
0.0 0.0
0.1 0.1
20.0 20.0
./
smoke.bin
1
100
00 00 00 00 00
00 00 00 00 00
00 00 00
1
5.0 6.0 1.0
0.0 0.0 0.0 0.0 0.0
0.0 0.0 0.0
0.0
0.0

Re: Help with HYSPLIT Concentration Setup

Posted: November 5th, 2020, 4:28 pm
by katherinebee13
Thank you very much for your reply. For some reason, when i run these with the changes, I get a blank map. Do you have any ideas what might be causing this? I have attached the control/setup/emimtimes files I used.