values for cmax in conprob utility

Topics about the HYSPLIT dispersion model.
Post Reply
akp
Posts: 40
Joined: September 3rd, 2013, 9:34 pm
Registered HYSPLIT User: No

values for cmax in conprob utility

Post by akp »

Hello,

I would like to enter my own values for cmax when processing ensemble results with conprob. I would like to enter values that correspond to PM2.5 concentration values for cmax but these would all be positive exponents with the exception of the lowest value. The documentation says that any value I enter will be the negative exponent to the power ten. This would only allow very low concentration levels to be processed. Perhaps this is due to the description in the documentation.

-Andre
Post Reply

Return to “Dispersion Model”