Page 1 of 1
Clarification of Concentration values output from con2asc -c
Posted: August 15th, 2019, 9:20 am
I have run Hysplit4 dispersion with say a few height level say 0, 5, 10, and 50m. I used the command con2asc to generate the concentration values in ascii. Does the 5m, 10m and 50m concentration level outputs refer to concentration averaged from 0 to 5m, 5m to 10m and 10m to 50m respectively?
Re: Clarification of Concentration values output from con2asc -c
Posted: August 19th, 2019, 7:36 am
Yes, assuming you are running the default particle (not puff) model. Please see the corresponding HELP information at https://ready.arl.noaa.gov/hysplitusersguide/S313.htm
Note you are running at a much finer vertical resolution than is typical so you need more model computational particles. The model has not been evaluated against measurements at this vertical resolution.