<r>Hi everyone, <br/>
I asked about Testing of Captex2 Simulation and getting different results.<br/>
I mentioned that although ı did all things with Hysplit video tutorial identically for chapter8 "Configuring the CAPTEX simulation".<br/>
I set up concentration that is the same as the tutorial, run the example and gave the result like below.<br/>
when ı open the Message file and compare the results, they were different.<br/>
<br/>
<B><s></s>Firstly, emission terminated part. <e></e></B><br/>
"Notice advring" is the diffrent end of the emission<br/>
in tutorial:1 17 17 1 2<br/>
in my case: in the tutorial:1 17 17 1 3<br/>
<br/>
<B><s></s>secondly, end of the 6 hours they have different boundary layers and of course, the mass fraction of layers are also different.<e></e></B><br/>
in the tutorial:12 layers<br/>
in my case: in the tutorial:14 layers<br/>
<br/>
End of the simulation particle numbers are different<br/>
in the tutorial: 24940 <br/>
in my case: in the tutorial:17737<br/>
<br/>
<B><s></s>Display shapes are the same but not identical and max. min concentrations are also different<e></e></B><br/>
in the tutorial: max=7.1E+02 pg/m3, min=3.4E-03 pg/m3<br/>
in my case: in the tutorial: max=4.7E+02 pg/m3, min=4.0E-03 pg/m3<br/>
<br/>
<B><s></s>The last one I wanted to create an animation but ı gave this error message "Error: invalid Parameter--density"<e></e></B><br/>
<br/>
What are the reasons for?<br/>
Best regars,<br/>
<br/>
<B><s></s>"Details of error"<br/>
<e></e></B><br/>
Invalid Parameter - -density<br/>
Invalid Parameter - -density<br/>
while executing<br/>
"exec $magick_pgm -quiet -density $Density -loop 100 -delay 30 -trim +repage -dispose Background $Input_file $Output_file"<br/>
(procedure "run_magick" line 32)<br/>
invoked from within<br/>
"run_magick"<br/>
invoked from within<br/>
".magick.bot.save invoke"<br/>
("uplevel" body line 1)<br/>
invoked from within<br/>
"uplevel #0 [list $w invoke]"<br/>
(procedure "tk::ButtonUp" line 24)<br/>
invoked from within<br/>
"tk::ButtonUp .magick.bot.save"<br/>
(command bound to event)</r>
Testing of Captex2 Simulation
Re: Testing of Captex2 Simulation
This sounds to me that the CONTROL and SETUP.CFG were configured differently than the tutorial. Those files are available to download at the bottom of the tutorial page: https://ready.arl.noaa.gov/documents/Tu ... _cexp.html
Would you upload those two files? That will be helpful to know how the run was set up.
Would you upload those two files? That will be helpful to know how the run was set up.