merging cdump files
Posted: October 20th, 2018, 3:45 pm
Dear HYSPLIT Community,
I have run every day a simulation for 15 days, i got 15 cdump files.
when i try to merge these files, it says the grid is different, even if i have same grid in control file ( only date change).
I want to merge those 15 files (each having 24-hours time steps in a single file? Is it possible to merge? If so, please suggest me how to do it.
With conappend after first file, the error is
FATAL ERROR: horizontal grids differ
With concadd
WARNING: meteorology start times differ
WARNING: release start times differ
WARNING: grid corners different
WARNING: time mismatch between input files!
Still its merging to single file, when i open in display or convert to ascii, it shows only first file information.
I thought that I can convert all files into single grid and try to merge them, but not able to do it. Could you please suggest me
Still I dont understand that, even if I specify the model domain center point and span area, still the model takes another grid and runs model, how is it possible?
Any help in this regard is appreciated.
Thanks in advance
Sree
I have run every day a simulation for 15 days, i got 15 cdump files.
when i try to merge these files, it says the grid is different, even if i have same grid in control file ( only date change).
I want to merge those 15 files (each having 24-hours time steps in a single file? Is it possible to merge? If so, please suggest me how to do it.
With conappend after first file, the error is
FATAL ERROR: horizontal grids differ
With concadd
WARNING: meteorology start times differ
WARNING: release start times differ
WARNING: grid corners different
WARNING: time mismatch between input files!
Still its merging to single file, when i open in display or convert to ascii, it shows only first file information.
I thought that I can convert all files into single grid and try to merge them, but not able to do it. Could you please suggest me
Still I dont understand that, even if I specify the model domain center point and span area, still the model takes another grid and runs model, how is it possible?
Any help in this regard is appreciated.
Thanks in advance
Sree