HYSPLIT Forum: hysplitbbs.arl.noaa.gov

Dear all

I want to make a setup file for modeling dust storm and calculating the PM10 concentration on Special Place Tehran ( 30N, 40E ).
The domain i consider in my setup file is (15E-60N, 30E-60E) and i want to make this domain to some nine(9) sub-domain like (30-45N, 40-50E).
the meteorological data want to use in my setup is:

20150610_gdas0p5
20150611_gdas0p5
20150612_gdas0p5
20150613_gdas0p5
20150614_gdas0p5
20150615_gdas0p5

I also downloaded the Dust emission rate and the friction velocity of each grid point from HYSPLIT tutorial page (12.1-the data is attached to this conversation).
example:
15.25 30.25 10 74.7 4.480E+06

https://www.ready.noaa.gov/documents/Tu ... _dust.html
I tried many time for considering the dust PM10 concentration!
Even though i run the setup file mentioned in the tutorial page(12.1-dust storm). i can not do the same thing for with the same setup by new metrological data and grid point!

and when i want to display the concentration and dust emission rate i encounter with this message: "concplot.ps not found"

what is my problem!

thanks for your time and consideration in advance

Regards

Please check your MESSAGE file. You are probably not emitting any particles because the friction velocity did not exceed the threshold friction velocity.