Ensemble starting heights

Topics about the HYSPLIT trajectory model.
Post Reply
arl.noaa
Posts: 33
Joined: November 9th, 2012, 2:49 pm
Registered HYSPLIT User: No

Ensemble starting heights

Post by arl.noaa » December 7th, 2012, 2:59 pm

I am frequently calculating trajectory ensembles starting withing the PBL using the HYSPLIT ensemble mode. Usually I use 500 m agl as starting height and leave the default grid offset parameters (DXF, DYF, DZF) untouched. In the HYSPLIT manual it is said, that the default DZF of 0.01 sigma units corresponds to approx. 250 m.

I am not a meteorologist, but I now realized that in the standard atmosphere, 0.01 sigma units rather correspond to approx. 100 m close to the ground. Is the sigma in HYSPLIT defined differently?

Or, in other words, if I would like to start my trajectory ensembles closer to the ground (let's say at 100 m agl), what would be a good sigma to use for DZY in the HYSPLIT model?

Thanks for your help.

glenn.rolph
Posts: 362
Joined: November 7th, 2012, 1:39 pm
Registered HYSPLIT User: Yes
Contact:

Re: Ensemble starting heights

Post by glenn.rolph » December 7th, 2012, 3:00 pm

The standard atmosphere goes much higher. In the HYSPLIT sigma-height coordinate, the model top is 25 km, that is why 0.01 sigma = 250 m

Post Reply