different results in calculation of back-trajectories when using splitr

Topics about the HYSPLIT trajectory model.
Post Reply
maiacalvello2
Posts: 3
Joined: February 10th, 2020, 10:31 am
Registered HYSPLIT User: No

different results in calculation of back-trajectories when using splitr

Post by maiacalvello2 » February 20th, 2020, 5:35 am

I'm using splitr to simultaneously calculate trajectories but when comparing the tdump.file downloaded from the Hysplit online model and the one produced by splitr I found differences in trajectories calculation. Attached you can find the config part for the splitr routine.
Attachments
config.docx
Since the default minimum ML height in splitr (kmix parameter) is 250, we added this config part setting kmix to 0 as in Hysplit online version
(11.85 KiB) Downloaded 26 times

sonny.zinn
Posts: 27
Joined: May 8th, 2019, 1:31 pm
Registered HYSPLIT User: Yes

Re: different results in calculation of back-trajectories when using splitr

Post by sonny.zinn » February 21st, 2020, 8:05 am

After a trajectory run with READY (or online HYSPLIT), you will see links to the HYSPLIT SETUP file and the HYSPLIT CONTROL file. You might want to download them and compare them with what goes into your splitr calculation.

Post Reply