Problem setting up cluster analysis
Posted: July 20th, 2020, 3:09 pm
I am trying to run a 24 hr cluster analysis on 35 backward trajectories. I have the placed the tdump files in the endpts folder and am able to generate the INFILE without any problem. I have manually inspected the INFILE and everything looks good (has all the files I need). However, when I run the cluster analysis I get the following prompt also shown in attachment:
Model started ... it is slower at the beginning
Started Cluster (Version: April 2015)
Number of trajectories in INFILE: 35
Pass 1 out of 1
Complete Cluster - number of trajectories clustered:
The TSV is empty. If I ignore this and try lookup the final number of clusters I get an error ehich I have expanded the details below:
Started Clusend (Version: November 2009)
min # trajectories, 15 , not met ( 3 )
504
Started Clusend (Version: November 2009)
min # trajectories, 15 , not met ( 3 )
504
while executing
"exec $exec_dir/clusend.exe $arg1 $arg2 $arg3 $arg4 $arg5 $arg6"
(procedure "List_outcomes" line 43)
invoked from within
"List_outcomes"
invoked from within
".trajclus.ncout.cont invoke"
("uplevel" body line 1)
invoked from within
"uplevel #0 [list $w invoke]"
(procedure "tk::ButtonUp" line 24)
invoked from within
"tk::ButtonUp .trajclus.ncout.cont"
(command bound to event)
Since I have 35 trajectories I don't get how I failing to meet the minimum requirements. I appreciate any feedback because I can't figure out where I am going wrong or what the issue is. I am also using the GUI.
Model started ... it is slower at the beginning
Started Cluster (Version: April 2015)
Number of trajectories in INFILE: 35
Pass 1 out of 1
Complete Cluster - number of trajectories clustered:
The TSV is empty. If I ignore this and try lookup the final number of clusters I get an error ehich I have expanded the details below:
Started Clusend (Version: November 2009)
min # trajectories, 15 , not met ( 3 )
504
Started Clusend (Version: November 2009)
min # trajectories, 15 , not met ( 3 )
504
while executing
"exec $exec_dir/clusend.exe $arg1 $arg2 $arg3 $arg4 $arg5 $arg6"
(procedure "List_outcomes" line 43)
invoked from within
"List_outcomes"
invoked from within
".trajclus.ncout.cont invoke"
("uplevel" body line 1)
invoked from within
"uplevel #0 [list $w invoke]"
(procedure "tk::ButtonUp" line 24)
invoked from within
"tk::ButtonUp .trajclus.ncout.cont"
(command bound to event)
Since I have 35 trajectories I don't get how I failing to meet the minimum requirements. I appreciate any feedback because I can't figure out where I am going wrong or what the issue is. I am also using the GUI.