Hysplit on R studio:

Post questions, comments and links to research (research papers, web sites, etc) involving HYSPLIT and wildfire smoke. This section is also to facilitate collaborations between researchers involved in smoke transport and dispersion.
Post Reply
rubi.arrizaga
Posts: 1
Joined: March 14th, 2024, 8:23 am
Registered HYSPLIT User: No

Hysplit on R studio:

Post by rubi.arrizaga »

Hello!
By using the model_height command, which defines the upper limit of the model domain in meters, I set a maximum height of 1,500 meters. However, upon reviewing the resulting table, I observe that the reported values reach up to 2,700 meters. why does this discrepancy occur?
Top
alicec
Posts: 419
Joined: February 8th, 2016, 12:56 pm
Registered HYSPLIT User: Yes

Re: Hysplit on R studio:

Post by alicec »

Could you provide more information.
In particular it would be nice to see your CONTROL file for the run and also whether you are running
trajectory or dispersion. What is in the resulting table?
Top
Post Reply

Return to “Wildfire Smoke”