How to calculate total mass accumulated in a colum?

Post questions, comments and links to research (research papers, web sites, etc) involving HYSPLIT and volcanic ash. This section is also to facilitate collaborations between researchers involved in volcanic ash transport and dispersion.
Post Reply
tschonholz
Posts: 29
Joined: May 8th, 2013, 11:42 am
Registered HYSPLIT User: Yes
Location: Argentina
Contact:

How to calculate total mass accumulated in a colum?

Post by tschonholz » May 21st, 2013, 2:57 pm

I was wondering how to calculate accumulated mass in a column (in tn/ km^2 maybe) for a volcanic ash run.
I was using concentration but it's not representative of the case.

Thanks for any advice.
Tamara Schonholz

barbara.stunder
Posts: 196
Joined: November 9th, 2012, 4:23 pm
Registered HYSPLIT User: Yes

Re: How to calculate total mass accumulated in a colum?

Post by barbara.stunder » May 23rd, 2013, 7:52 am

To get the mass in a column, multiply the concentration by the depth of the column over which the concentration is calculated.

Amount of mass in the eruption, height of the eruption, and how quickly the particles fall out can all affect the results.

tschonholz
Posts: 29
Joined: May 8th, 2013, 11:42 am
Registered HYSPLIT User: Yes
Location: Argentina
Contact:

Re: How to calculate total mass accumulated in a colum?

Post by tschonholz » May 26th, 2013, 11:50 pm

Thank you for your reply.
But there is no way to actually get it done by GUI, right?
I want to compare the outcome of HYSPLIT with other dispersion models, and they seem to show results in mass accumulated in a colum.
May it be possible?

Thanks a lot! I´m learning so much!
Tamara Schonholz

barbara.stunder
Posts: 196
Joined: November 9th, 2012, 4:23 pm
Registered HYSPLIT User: Yes

Re: How to calculate total mass accumulated in a colum?

Post by barbara.stunder » May 28th, 2013, 8:07 am

We plan to add output as mass loading for volcanic ash, but that is not available yet.

Through the web, it is not possible to multiply the output by a constant. Through the PC GUI, on the "Concentration Display" window there is an entry "Concentration multiplier" where this can be done.

tschonholz
Posts: 29
Joined: May 8th, 2013, 11:42 am
Registered HYSPLIT User: Yes
Location: Argentina
Contact:

Re: How to calculate total mass accumulated in a colum?

Post by tschonholz » March 6th, 2014, 4:13 pm

Do we have any advance in this or still planning?
Thanks!!
Tamara Schonholz

barbara.stunder
Posts: 196
Joined: November 9th, 2012, 4:23 pm
Registered HYSPLIT User: Yes

Re: How to calculate total mass accumulated in a colum?

Post by barbara.stunder » March 18th, 2014, 2:34 pm

Yes, for volcanic ash simulations, mass loading is output under the "(NEW) Compute archive volcanic ash concentrations" at http://www.ready.noaa.gov/HYSPLIT_ash.php

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest