Error while running hycm_std

Post any questions or comments regarding the LINUX version of HYSPLIT. This includes the model execution, GUIs, results, or graphics. Be sure to mention the version of LINUX you are using.
Post Reply
indumati_sp
Posts: 15
Joined: November 20th, 2012, 12:46 am
Registered HYSPLIT User: Yes

Error while running hycm_std

Post by indumati_sp »

I am getting the following error while running the MPI version of the model (hycm_std).
"puff dispersion (initd=1,2) not optimized for MPI".

Kindly advice on how to resolve this .

Thanks in advance.
barbara.stunder
Posts: 421
Joined: November 9th, 2012, 4:23 pm
Registered HYSPLIT User: Yes

Re: Error while running hycm_std

Post by barbara.stunder »

You are getting that message, which also says "Simulation will continue on one processor!"
because you are running with puffs (initd=2,3 or 4). If you can change to the particle mode initd=0 for 3-d particle, or initd=1 (Gaussian-horizontal vertical puff), then it will run as multi-processor. The initd=0 is the default. Please try that.
Post Reply