Hi,
I have a question about Hysplit that I haven't been able to answer myself by going through the manual or looking online. In the Concentration / Setup Run / Deposition definition, what are the values for the "Shape" parameter and what do they mean? I notice that Shape is set to 0.0 if the pollutant is a gas and 1.0 if the pollutant is a particle. I didn't know if there were other values or if all particles should be 1.0 and all gasses 0.0.
Shape parameter for particles
-
- Posts: 362
- Joined: November 7th, 2012, 1:39 pm
- Registered HYSPLIT User: Yes
Re: Shape parameter for particles
See ARL-224 in the documents directory. The shape factor is only applied to particles.
The settling velocity is then adjusted for a slip correction (Cc) for small particles and a dynamic shape factor (α) to account for non-spherical particles. Hence the final settling velocity is
Vs = Vg Cc α-1, (90)
where α can vary between 1.0 to 2.0
The settling velocity is then adjusted for a slip correction (Cc) for small particles and a dynamic shape factor (α) to account for non-spherical particles. Hence the final settling velocity is
Vs = Vg Cc α-1, (90)
where α can vary between 1.0 to 2.0