When I “Run Standard Model” after saving the “Trajectory Setup”, I get a static message Model started … HYSPLIT48
Posted: July 22nd, 2021, 1:22 pm
[Note that the question and the answer below are recreated from a HYSPLIT FAQ site that predates this forum site. The original author and the posting date are unknown.]
Question:
When I “Run Standard Model” after saving the “Trajectory Setup”, I get a static message Model started … HYSPLIT48 (February 2008) – Initialization This does not change. Why?
Answer:
First look in the message file, if that doesn’t help …
Now go to setup menu,
Now go to setup and change one item at a time to match your desired run. With each change, save, run, and display to make sure it works
At the point it doesn’t, you know the point of failure.
Question:
When I “Run Standard Model” after saving the “Trajectory Setup”, I get a static message Model started … HYSPLIT48 (February 2008) – Initialization This does not change. Why?
Answer:
First look in the message file, if that doesn’t help …
- Trajectory – Quick Start – Run Example
- Right Click map, close window
Now go to setup menu,
- save
- Run model
- Display
Now go to setup and change one item at a time to match your desired run. With each change, save, run, and display to make sure it works
At the point it doesn’t, you know the point of failure.