Search found 5 matches
- October 21st, 2014, 1:25 am
- Forum: Cluster Analysis
- Topic: Error- none to cluster
- Replies: 3
- Views: 7276
Re: Error- none to cluster
Hi Barbara, Thank you for your reply. I did this and managed to make the INFILE. I then pressed 'run cluster analysis.' It's been on this screen for almost an hour... Model started ... it is slower at the beginning Started Cluster (Version: January 2010) Number of trajectories in INFILE: 120 I skipp...
- October 19th, 2014, 12:17 am
- Forum: Cluster Analysis
- Topic: Error- none to cluster
- Replies: 3
- Views: 7276
Error- none to cluster
Hi there I am new to hysplit and I'm having some difficulties with the cluster analysis. I am trying to cluster single hourly trajectories for one location. I set up and ran these trajectories individually and saved them in my working folder (from the setup run screen) When I try to cluster them, I ...
- October 15th, 2014, 10:59 am
- Forum: HYSPLIT for PCs
- Topic: Cluster anaylsis
- Replies: 2
- Views: 4636
Cluster anaylsis
Hi,
I'm running hourly back trajectories for duration of 168 hours, for a number of different days for the one site.
I want to compile all these trajectories onto one output
How would I go about this? Would I use the cluster analysis? Does it matter that there are different days?
Thank you!
I'm running hourly back trajectories for duration of 168 hours, for a number of different days for the one site.
I want to compile all these trajectories onto one output
How would I go about this? Would I use the cluster analysis? Does it matter that there are different days?
Thank you!
- October 1st, 2014, 11:58 am
- Forum: Trajectory Model
- Topic: Trajectory setup- output
- Replies: 2
- Views: 2595
Re: Trajectory setup- output
Thank you very much for your response!
Problem fixed
Cheers,
Steph
Problem fixed
Cheers,
Steph
- October 1st, 2014, 1:13 am
- Forum: Trajectory Model
- Topic: Trajectory setup- output
- Replies: 2
- Views: 2595
Trajectory setup- output
Hi there, I am having trouble running my trajectory that I have setup in the "setup run". Once I put in all the information, I press save and the program closes as it should. But then when I go to trajectory- run model, the simulation log comes up with this message: "Model started... couldn't execut...